Remove the highlighted nodes shown below, location shown at the top of the screenshot.

Then connect the nodes up like shown below.

Next add the highlighted node shown in the image below, location shown at the top of the screenshot.

Next disconnect the code shown in the image below, location shown at the top of the screenshot.

Next i the BTT_RangeMoveTo blueprint create a new function called Range Point Check and add 1 output called Return Value and set it to Bool. Then copy the image below.

Next us the new function you just created and add it like the image below shows.

Next go to the EQS_Cover, then untick the box that the red arrow is pointing to in the image below. Then select the node pointed at by the green arrow, then copy the settings on the right side of the image and save.